Samsung washer
showing 4C2
4C2 means the water arriving on the cold side is very hot, which almost always means the hot and cold hoses are swapped.
Mon–Sat, 8am–8pm
- Water supply
- Water inlet valve repair
- Source: Samsung
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What 4C2
actually means.
4C2 means the water arriving on the cold side is very hot, which almost always means the hot and cold hoses are swapped.
Samsung washer display · also shown as 4E2, CE, 14C2, nF1
What to do when 4C2 shows on the washerKind of codeWater supply
Water arrived too slowly, not at all, or kept coming after it should have stopped. The supply valves on the wall and the screens inside the fill hoses are checked before the inlet valve or the level sensor.
Usually leads toWater inlet valve repair
A washer that will not fill, fills slowly, fills with only cold water or keeps filling, repaired at the inlet valve and its screens.
Shows up asWasher Not Filling
The washer starts, hums or clicks, but little or no water comes into the tub, or it fills very slowly.
MakeSamsung
Front-load and top-load washers from the Korean maker, built around electronic controls and load sensing.
SourceSamsung US support: Samsung washing machine information and error codes (read 24 Sep 2026)
Samsung washers; also shown as 4E2, CE, 14C2 or nF1.
Before you book,
in this order.
Each step comes from Samsung's own guidance for 4C2 on its washers. Follow it to the end: the last card says whether this is a visit.
Turn off both supply valves.
Reconnect the hoses so cold feeds the cold inlet and hot feeds the hot inlet, usually blue to blue and red to red.
Open the valves and run a short cycle.
Still there?
It usually turns into water inlet valve repair. Book with the code and the model number.
What not to do
4C2 is not a repair item; Samsung says it does not indicate a need for service.
What you may
notice with it.
The washer problems 4C2 tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Where 4C2 usually leads
Water inlet valve repair.
Samsung
washers.
Front-load and top-load washers from the Korean maker, built around electronic controls and load sensing.
Samsung washer repairMore Samsung codes
Water supply on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Top-load washer
The upright washer with a lid on top, moving clothes either with a tall central agitator or with a low impeller plate in the bottom of the basket.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
In Samsung's own words
The water from the cold water supply is extremely hot.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Samsung washers; also shown as 4E2, CE, 14C2 or nF1.
Samsung 4C2 washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about 4C2.
Can I clear 4C2 myself?
Does 4C2 on a Samsung washer mean the water heater is too hot?
Is CE on my Samsung washer the same as 4C2?
Back to your everyday
Still showing 4C2?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.