The back of a washer where two braided fill hoses screw onto the inlet valve ports, the hot and cold supply valves on the wall above them.

Asko washer
showing E3

E3 means the washer did not fill with water as expected.

(844) 398-5711

Mon–Sat, 8am–8pm

  • Water supply
  • Water inlet valve repair
  • Source: ASKO

Book a visit

Three short steps, about a minute.

or call (844) 398-5711

Before you book,
in this order.

Each step comes from ASKO's own guidance for E3 on its washers. Follow it to the end: the last card says whether this is a visit.

01

Make sure the water faucet is open.

02

Clean the filter on the inlet hose and check the hose is not crushed or clogged.

03

Press Exit to resume the program; book a visit if E3 returns.

Still there?

It usually turns into water inlet valve repair. Book with the code and the model number.

What not to do

E3 is not an overflow; E11 covers too much water.

What you may
notice with it.

The washer problems E3 tends to arrive with. Answer these at the washer before anyone is booked.

All problems

Where E3 usually leads

Water inlet valve repair.

Water inlet valve and fill hoses · low.

In ASKO's own words

WATER FILLING ERROR
Asko W4114C user manual, WM85.1 platform (PDF on the Gorenje document server) Asko W4114C user manual, WM85.1 platform (PDF on the Gorenje document server) Asko W4114C user manual, WM85.1 platform (PDF on the Gorenje document server)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko W4114C (Logic, WM85 platform), per its user manual; the display shows "Error" and the number, and the INFO button shows the description.

ASKO E3 washer repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child loading towels into an open front-load washer together in a bright laundry room
For the heart of your home.

Questions
about E3.

Can I clear E3 myself?
Make sure the water faucet is open. If it comes back, it needs a visit.
Can I resume the program after E3 on my Asko?
Yes. After the checks, Asko has you press Exit to continue the program.
What water pressure does an Asko washer need to avoid E3?
The manual gives a range of 0.1 to 1 MPa (about 15 to 145 psi) in the water mains.

Back to your everyday

Still showing E3?

Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 398-5711 Schedule a repair