The back of a washer where two braided fill hoses screw onto the inlet valve ports, the hot and cold supply valves on the wall above them.

Bosch washer
showing E:00 -23

On the 800 Series, E:00 alternating with -23 means there is water in the base of the washer: the machine is leaking inside its cabinet.

(844) 398-5711

Mon–Sat, 8am–8pm

  • Water supply
  • Water inlet valve repair
  • Source: Bosch

Book a visit

Three short steps, about a minute.

or call (844) 398-5711

Before you book,
in this order.

Each step comes from Bosch's own guidance for E:00 -23 on its washers. Follow it to the end: the last card says whether this is a visit.

01

Turn off the water faucets.

02

Unplug the washer or switch off its breaker if water has reached the floor.

03

Book a visit; Bosch gives no owner fix for water in the base.

Still there?

It usually turns into water inlet valve repair. Book with the code and the model number.

What not to do

This code does not mean the drum is overfilled; the water has escaped into the bottom of the washer.

What you may
notice with it.

The washer problems E:00 -23 tends to arrive with. Answer these at the washer before anyone is booked.

All problems

Where E:00 -23 usually leads

Water inlet valve repair.

Water inlet valve and fill hoses · low.

In Bosch's own words

Turn off the water tap.
Bosch WAW285H2UC (800 Series) use and care manual (PDF on the BSH media server) Bosch WAW285H2UC 800 Series spec sheet (PDF on the BSH media server) Bosch WAW285H2UC (800 Series) use and care manual (PDF on the BSH media server)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch 800 Series WAW285H2UC, which carries AquaStop Plus leak protection with a base sensor.

Bosch E:00 -23 washer repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child loading towels into an open front-load washer together in a bright laundry room
For the heart of your home.

Questions
about E:00 -23.

Can I clear E:00 -23 myself?
Turn off the water faucets. If it comes back, it needs a visit.
Why does my Bosch 800 washer refuse to run after E:00 -23?
The base has detected water, and the AquaStop protection is designed to stop the washer taking in more until the leak is found.
Can I dry out the base myself and reset E:00 -23 on a Bosch?
The manual's only step is to turn off the water tap and have the washer checked, because the leak that filled the base still needs to be found.

Back to your everyday

Still showing E:00 -23?

Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 398-5711 Schedule a repair