Samsung washer
showing SUd
SUd tells you the washer detected too much foam and paused to let it settle.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Samsung
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What SUd
actually means.
SUd tells you the washer detected too much foam and paused to let it settle. The cycle resumes by itself.
Samsung washer display · also shown as 5UD, Sd, 5d, SUdS
What to do when SUd shows on the washerKind of codeMode, not a failure
Something the washer does by design, or a setting somebody turned on — a child lock, a prompt to run a cleaning cycle, a paused cycle waiting for the door. No part has failed and nothing needs replacing.
Usually leads toNo repair
Let the washer wait out the pause; it continues on its own.
Shows up asWasher Stops Mid-Cycle
The washer starts normally, then pauses, stalls or shuts off before the cycle ends, sometimes with water still inside.
MakeSamsung
Front-load and top-load washers from the Korean maker, built around electronic controls and load sensing.
SourceSamsung US support: Samsung washing machine information and error codes (read 24 Sep 2026)
Samsung front-load and top-load washers; also shown as 5UD, Sd, 5d or SUdS.
Before you book,
in this order.
Each step comes from Samsung's own guidance for SUd on its washers. Follow it to the end: the last card says whether this is a visit.
Let the washer wait out the pause; it continues on its own.
Use HE detergent and measure it for the next load.
Cleared?
No part had to be replaced. If a later load stops with water left in the drum or the cycle halts again, treat it as a new problem.
What not to do
SUd is not a repair signal; Samsung ties it to detergent use.
What you may
notice with it.
The washer problems SUd tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Washer Stops Mid-Cycle
5 causes, cheapest first
No repair indicated
Nothing to repair.
Something the washer does by design, or a setting somebody turned on — a child lock, a prompt to run a cleaning cycle, a paused cycle waiting for the door. No part has failed and nothing needs replacing.
Samsung
washers.
Front-load and top-load washers from the Korean maker, built around electronic controls and load sensing.
Samsung washer repairMore Samsung codes
Mode, not a failure on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Top-load washer
The upright washer with a lid on top, moving clothes either with a tall central agitator or with a low impeller plate in the bottom of the basket.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
In Samsung's own words
The washer has detected an over-sudsing condition and will stop for a short period to allow the suds to dissipate.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Samsung front-load and top-load washers; also shown as 5UD, Sd, 5d or SUdS.
Samsung SUd washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about SUd.
Can I clear SUd myself?
Why does SUd flash again at the end of my Samsung cycle?
Can SUd on a Samsung washer lead to a leak code?
Back to your everyday
Still showing SUd?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.