Miele washer
showing F15
F15 means the hot water intake is blocked or restricted, on Miele washers connected to a hot water supply.
Mon–Sat, 8am–8pm
- Water supply
- Water inlet valve repair
- Source: Miele
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F15
actually means.
F15 means the hot water intake is blocked or restricted, on Miele washers connected to a hot water supply.
Miele washer display
What to do when F15 shows on the washerKind of codeWater supply
Water arrived too slowly, not at all, or kept coming after it should have stopped. The supply valves on the wall and the screens inside the fill hoses are checked before the inlet valve or the level sensor.
Usually leads toWater inlet valve repair
A washer that will not fill, fills slowly, fills with only cold water or keeps filling, repaired at the inlet valve and its screens.
Shows up asWasher Not Filling
The washer starts, hums or clicks, but little or no water comes into the tub, or it fills very slowly.
MakeMiele
German-built compact front-load washers, many with automatic detergent dosing, made for long service lives.
SourceMiele USA customer assistance, washer page F15 (Wayback copy)
Miele washers and washer-dryers with a hot water connection.
Before you book,
in this order.
Each step comes from Miele's own guidance for F15 on its washers. Follow it to the end: the last card says whether this is a visit.
Cancel the program, open the hot water faucet and restart.
Turn the hot faucet off, unscrew the hose and clean its inlet filter, then refit it.
Check that the fully open hot faucet delivers at least 5 liters in 15 seconds.
Still there?
It usually turns into water inlet valve repair. Book with the code and the model number.
What not to do
F15 is about the hot supply only; the cold supply is covered by F10.
What you may
notice with it.
The washer problems F15 tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Where F15 usually leads
Water inlet valve repair.
Miele
washers.
German-built compact front-load washers, many with automatic detergent dosing, made for long service lives.
Miele washer repairMore Miele codes
Water supply on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
Compact washer
The 24-inch front-loaders and all-in-one washer-dryers found in apartments, condos and under counters, repaired on their washing side.
In Miele's own words
The hot water faucet has not been opened.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele washers and washer-dryers with a hot water connection.
Miele F15 washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F15.
Can I clear F15 myself?
Why does my Miele show F15 when cold washes work fine?
Must the hot water filter go back in after cleaning it for F15?
Back to your everyday
Still showing F15?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.