Miele washer
showing F1
F1 means there is a short circuit in the heating or water-temperature sensor circuit.
Mon–Sat, 8am–8pm
- Sensor circuit
- Controls and sensors
- Source: Miele
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F1
actually means.
F1 means there is a short circuit in the heating or water-temperature sensor circuit.
Miele washer display
What to do when F1 shows on the washerKind of codeSensor circuit
A water level sensor, a temperature sensor or the wiring to one of them is reporting a value outside its range. The reading and the small air hose to the level sensor are checked with a meter before any part is ordered.
Usually leads toControls and sensors
A dead display, buttons that do nothing, cycles that stop at random or codes that keep returning, traced to the control, its sensors or its wiring.
Shows up asClothes Still Dirty After Washing
Laundry comes out with stains, residue, lint or streaks of detergent, or smells unwashed.
MakeMiele
German-built compact front-load washers, many with automatic detergent dosing, made for long service lives.
SourceMiele USA customer assistance, washer page F1 (Wayback copy)
Miele washers and washer-dryers.
Before you book,
in this order.
Each step comes from Miele's own guidance for F1 on its washers. Follow it to the end: the last card says whether this is a visit.
Switch the washer off.
Book a repair visit.
What not to do
F1 is not a supply or drain problem; it is an electrical issue in the temperature sensing.
What you may
notice with it.
The washer problems F1 tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Clothes Still Dirty After Washing
5 causes, cheapest first
Where F1 usually leads
Controls and sensors.
Miele
washers.
German-built compact front-load washers, many with automatic detergent dosing, made for long service lives.
Miele washer repair
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
Compact washer
The 24-inch front-loaders and all-in-one washer-dryers found in apartments, condos and under counters, repaired on their washing side.
In Miele's own words
Short circuit in heating/water-temperature sensor circuit.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele washers and washer-dryers.
Miele F1 washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F1.
Can I clear F1 myself?
Can I keep washing in cold water with F1 on my Miele?
Is F1 on a Miele the heater itself?
Back to your everyday
Still showing F1?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.