The lower front access panel of a front-load washer opened, the round drain pump filter cap exposed and a shallow tray set on the floor beneath it.

Miele washer
showing F210

F210, also shown as "Check filter + nozzle", means a problem in the suds circulation system: a blocked nozzle at the top of the door seal or a blocked drain filter.

(844) 398-5711

Mon–Sat, 8am–8pm

  • Drain
  • Drain pump repair
  • Source: Miele

Book a visit

Three short steps, about a minute.

or call (844) 398-5711

Before you book,
in this order.

Each step comes from Miele's own guidance for F210 on its washers. Follow it to the end: the last card says whether this is a visit.

01

Carefully remove lint from the nozzle at the top of the door seal with your finger.

02

Drain and clean the drain filter as for F11, with a container under the access panel.

03

Book a visit if the message returns.

Still there?

It usually turns into drain pump repair. Book with the code and the model number.

What not to do

F210 is not a door lock problem even though the nozzle sits at the door seal.

What you may
notice with it.

The washer problems F210 tends to arrive with. Answer these at the washer before anyone is booked.

All problems

Where F210 usually leads

Drain pump repair.

Drain pump, filter or drain hose · low.

In Miele's own words

The nozzle at the top of the door sealing ring is blocked.
Miele USA customer assistance, washer page F210 (Wayback copy) Miele USA customer assistance, washer page F210 (Wayback copy)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Miele washers with a suds circulation nozzle in the door seal.

Miele F210 washer repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child loading towels into an open front-load washer together in a bright laundry room
For the heart of your home.

Questions
about F210.

Can I clear F210 myself?
Carefully remove lint from the nozzle at the top of the door seal with your finger. If it comes back, it needs a visit.
Where is the nozzle Miele means for F210?
At the top of the door sealing ring. Lint collects there and can be removed carefully by hand.
Why does Miele send me to the drain filter for F210?
A blocked drain filter is the other cause Miele lists for the circulation problem, so both are cleaned.

Back to your everyday

Still showing F210?

Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 398-5711 Schedule a repair