A single heavy bath mat bunched against one side of an open top-load washer tub, the rest of the drum empty around it.

Bosch washer
showing E:32

E:32 means the washer stopped the spin because the laundry was unevenly spread in the drum.

(844) 398-5711

Mon–Sat, 8am–8pm

  • Unbalanced load
  • Suspension and shock repair
  • Source: Bosch

Book a visit

Three short steps, about a minute.

or call (844) 398-5711

Before you book,
in this order.

Each step comes from Bosch's own guidance for E:32 on its washers. Follow it to the end: the last card says whether this is a visit.

01

Redistribute the laundry evenly, mixing large and small items.

02

Start a separate Spin program if the clothes are still wet.

03

If it happens on every load, check that the washer is level and the transit bolts were removed.

Still there?

It usually turns into suspension and shock repair. Book with the code and the model number.

What not to do

E:32 is not a failed part; the WAT28400UC manual says plainly that it is a protective stop.

What you may
notice with it.

The washer problems E:32 tends to arrive with. Answer these at the washer before anyone is booked.

All problems

Where E:32 usually leads

Suspension and shock repair.

Shocks, springs or suspension rods · low.

In Bosch's own words

The appliance has interrupted the spin cycle because the laundry is unevenly distributed.
Bosch WGA12400UC (300 Series) user manual and installation instructions (PDF on the BSH media server) Bosch WGA12400UC (300 Series) user manual and installation instructions (PDF on the BSH media server) Bosch WGA12400UC (300 Series) user manual and installation instructions (PDF on the BSH media server)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch WAT28400UC (E:32, alternating with END); the newer 300 Series WGA12400UC lists E:60 -2B, E:32 and H:32.

Bosch E:32 washer repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A parent and a child loading towels into an open front-load washer together in a bright laundry room
For the heart of your home.

Questions
about E:32.

Can I clear E:32 myself?
Redistribute the laundry evenly, mixing large and small items. If it comes back, it needs a visit.
My Bosch shows E:32 and END. Did the wash finish?
The wash and rinse finished, but the final spin was cut short. Spread the load out and run a Spin program.
Why does my new Bosch washer shake and show E:32?
Bosch lists transit bolts left in place and a washer that is not aligned among the causes of heavy vibration, so check both after a new install.

Back to your everyday

Still showing E:32?

Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.

(844) 398-5711 Schedule a repair