Bosch washer
showing E:30 -10
On the newer 300 Series, E:30 -10 means water is not coming in as it should.
Mon–Sat, 8am–8pm
- Water supply
- Water inlet valve repair
- Source: Bosch
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E:30 -10
actually means.
On the newer 300 Series, E:30 -10 means water is not coming in as it should. Bosch lists a closed faucet, a kinked hose, blocked inlet filters, low pressure and a defective water level system.
Bosch washer display · also shown as E:92 -01
What to do when E:30 -10 shows on the washerKind of codeWater supply
Water arrived too slowly, not at all, or kept coming after it should have stopped. The supply valves on the wall and the screens inside the fill hoses are checked before the inlet valve or the level sensor.
Usually leads toWater inlet valve repair
A washer that will not fill, fills slowly, fills with only cold water or keeps filling, repaired at the inlet valve and its screens.
Shows up asWasher Not Filling
The washer starts, hums or clicks, but little or no water comes into the tub, or it fills very slowly.
MakeBosch
Compact 24-inch front-load washers from the German maker, designed to stack with a matching Bosch dryer.
SourceBosch WGA12400UC (300 Series) user manual and installation instructions (PDF on the BSH media server)
Bosch 300 Series WGA12400UC.
Before you book,
in this order.
Each step comes from Bosch's own guidance for E:30 -10 on its washers. Follow it to the end: the last card says whether this is a visit.
Turn the faucet on and check the inlet hose for kinks.
Clean the filters in the water inlet.
If the washer starts draining on its own, wait about 5 minutes for it to finish, then restart it.
Book a visit if the code returns.
Still there?
It usually turns into water inlet valve repair. Book with the code and the model number.
What not to do
E:30 -10 is not the same as E:30 -20, which Bosch treats as a critical condition.
What you may
notice with it.
The washer problems E:30 -10 tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Where E:30 -10 usually leads
Water inlet valve repair.
Bosch
washers.
Compact 24-inch front-load washers from the German maker, designed to stack with a matching Bosch dryer.
Bosch washer repairMore Bosch codes
Water supply on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
Compact washer
The 24-inch front-loaders and all-in-one washer-dryers found in apartments, condos and under counters, repaired on their washing side.
In Bosch's own words
The water level measuring system is defective.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Bosch 300 Series WGA12400UC.
Bosch E:30 -10 washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E:30 -10.
Can I clear E:30 -10 myself?
Why did my Bosch start draining when E:30 -10 appeared?
Is E:92 -01 on a Bosch 300 Series a different problem?
Back to your everyday
Still showing E:30 -10?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.