Asko washer
showing E10
E10 means the water level sensor is not reporting correctly.
Mon–Sat, 8am–8pm
- Sensor circuit
- Controls and sensors
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E10
actually means.
E10 means the water level sensor is not reporting correctly.
ASKO washer display
What to do when E10 shows on the washerKind of codeSensor circuit
A water level sensor, a temperature sensor or the wiring to one of them is reporting a value outside its range. The reading and the small air hose to the level sensor are checked with a meter before any part is ordered.
Usually leads toControls and sensors
A dead display, buttons that do nothing, cycles that stop at random or codes that keep returning, traced to the control, its sensors or its wiring.
Shows up asWasher Overflowing
The washer keeps filling past the normal level, and water spills over the tub, out of the door or onto the floor.
MakeASKO
Swedish-designed 24-inch front-load washers, sized for closets and often stacked under an Asko dryer.
SourceAsko W4114C user manual, WM85.1 platform (PDF on the Gorenje document server)
Asko W4114C (Logic, WM85 platform), per its user manual; the display shows "Error" and the number, and the INFO button shows the description.
Before you book,
in this order.
Each step comes from ASKO's own guidance for E10 on its washers. Follow it to the end: the last card says whether this is a visit.
Turn the washer off and on.
Start the program again; book a visit if E10 returns.
What not to do
E10 is not low water pressure at the faucet; the sensor is inside the washer.
What you may
notice with it.
The washer problems E10 tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Washer Overflowing
5 causes, cheapest first
Where E10 usually leads
Controls and sensors.
ASKO
washers.
Swedish-designed 24-inch front-load washers, sized for closets and often stacked under an Asko dryer.
ASKO washer repair
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
Compact washer
The 24-inch front-loaders and all-in-one washer-dryers found in apartments, condos and under counters, repaired on their washing side.
In ASKO's own words
WATER LEVEL SENSOR ERROR
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko W4114C (Logic, WM85 platform), per its user manual; the display shows "Error" and the number, and the INFO button shows the description.
ASKO E10 washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E10.
Can I clear E10 myself?
Can E10 on an Asko lead to overfilling?
What does a restart do for E10 on my Asko?
Back to your everyday
Still showing E10?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.