GE washer
showing Lid
GE top-loaders show Lid after three cycles start without the lid being opened.
Mon–Sat, 8am–8pm
- Door and lid lock
- Door lock and lid switch repair
- Source: GE
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Lid
actually means.
GE top-loaders show Lid after three cycles start without the lid being opened. The washer will not run another cycle until the lid goes up and comes back down.
GE washer display
What to do when Lid shows on the washerKind of codeDoor and lid lock
The control cannot confirm that the door or lid is locked, or cannot release it. A latch that does not reach the lock, a bent strike or water still in the tub is looked at before the lock assembly.
Usually leads toDoor lock and lid switch repair
A washer that will not start, will not spin or will not let go of the door, repaired at the lock, the lid switch or the striker.
Shows up asWasher Not Starting
The panel lights up but pressing start does nothing, or the washer shows no sign of power at all.
MakeGE
One of the most widespread washer brands in the US, in top-load, front-load and stacked laundry-center versions.
SourceGE Appliances support: Washer - Consumer Help Indicator
GE top-load washers with the Consumer Help Indicator.
Before you book,
in this order.
Each step comes from GE's own guidance for Lid on its washers. Follow it to the end: the last card says whether this is a visit.
Open the lid, then close it.
Start a new cycle.
If Lid keeps appearing when you do open it between loads, book a visit.
Still there?
It usually turns into door lock and lid switch repair. Book with the code and the model number.
What not to do
Lid is not a report that the lid is open right now. It counts cycles started without the lid being lifted.
What you may
notice with it.
The washer problems Lid tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Washer Not Starting
5 causes, cheapest first
Where Lid usually leads
Door lock and lid switch repair.
GE
washers.
One of the most widespread washer brands in the US, in top-load, front-load and stacked laundry-center versions.
GE washer repairMore GE codes
Door and lid lock on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Top-load washer
The upright washer with a lid on top, moving clothes either with a tall central agitator or with a low impeller plate in the bottom of the basket.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
In GE's own words
will be shown on the display if 3 cycles have been started without opening the lid
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. GE top-load washers with the Consumer Help Indicator.
GE Lid washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Lid.
Can I clear Lid myself?
Why does my GE show Lid when I run back-to-back rinse cycles?
Does Lid on a GE mean the lid switch is failing?
Back to your everyday
Still showing Lid?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.