GE Profile washer
showing Cycle Canceled Draining
The UltraFast Combo shows this message after being paused for more than 24 hours or after stopping itself before the end of a cycle; GE Profile washers with a scrolling display show CAnCELEd.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: GE Profile
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Cycle Canceled Draining
actually means.
The UltraFast Combo shows this message after being paused for more than 24 hours or after stopping itself before the end of a cycle; GE Profile washers with a scrolling display show CAnCELEd. A 4-minute lockout follows.
GE Profile washer display · also shown as CAnCELEd
What to do when Cycle Canceled Draining shows on the washerKind of codeMode, not a failure
Something the washer does by design, or a setting somebody turned on — a child lock, a prompt to run a cleaning cycle, a paused cycle waiting for the door. No part has failed and nothing needs replacing.
Usually leads toNo repair
Leave the unit plugged in and wait 4 minutes.
Shows up asWasher Stops Mid-Cycle
The washer starts normally, then pauses, stalls or shuts off before the cycle ends, sometimes with water still inside.
MakeGE Profile
GE's upper washer line, with more electronics, extra wash programs and all-in-one washer-dryer models.
SourceGE Appliances support: GE Profile UltraFast Combo Washer/Dryer error codes and status messages
GE Profile UltraFast Combo washer/dryer; GE Profile top-load and front-load washers show CAnCELEd.
Before you book,
in this order.
Each step comes from GE Profile's own guidance for Cycle Canceled Draining on its washers. Follow it to the end: the last card says whether this is a visit.
Leave the unit plugged in and wait 4 minutes.
Start the cycle again.
If the message appears on cycles that were never paused, book a visit.
Cleared?
No part had to be replaced. If a later load stops with water left in the drum or the cycle halts again, treat it as a new problem.
What not to do
It is not something to clear by unplugging. That only restarts the 4-minute timer.
What you may
notice with it.
The washer problems Cycle Canceled Draining tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Washer Stops Mid-Cycle
5 causes, cheapest first
No repair indicated
Nothing to repair.
Something the washer does by design, or a setting somebody turned on — a child lock, a prompt to run a cleaning cycle, a paused cycle waiting for the door. No part has failed and nothing needs replacing.
GE Profile
washers.
GE's upper washer line, with more electronics, extra wash programs and all-in-one washer-dryer models.
GE Profile washer repairMore GE Profile codes
Mode, not a failure on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Top-load washer
The upright washer with a lid on top, moving clothes either with a tall central agitator or with a low impeller plate in the bottom of the basket.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
In GE Profile's own words
If the Combo was paused for longer than 24 hours, or if the machine has stopped itself before the cycle was complete, the message that draining was canceled may show.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. GE Profile UltraFast Combo washer/dryer; GE Profile top-load and front-load washers show CAnCELEd.
GE Profile Cycle Canceled Draining washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Cycle Canceled Draining.
Can I clear Cycle Canceled Draining myself?
Why does my GE Profile say Cycle Canceled Draining after a weekend away?
Should I worry if my GE Profile keeps showing Cycle Canceled Draining?
Back to your everyday
Still showing Cycle Canceled Draining?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.