LG washer
showing CE
CE means the washer sensed too much current in the motor circuit.
Mon–Sat, 8am–8pm
- Drive motor
- Drive motor and belt repair
- Source: LG
Book a visit
Three short steps, about a minute.
or call (844) 398-5711
Loading appointment form…
The appointment form couldn’t load. Please try again.
What CE
actually means.
CE means the washer sensed too much current in the motor circuit. LG lists a short circuit, a loose connection, a ground problem or a power surge as the triggers.
LG washer display
What to do when CE shows on the washerKind of codeDrive motor
The control told the drum to turn and it did not turn as expected — a slipped or broken belt, a worn coupler, or a motor or its speed sensor reading out of range. The belt and the connections are checked before the motor.
Usually leads toDrive motor and belt repair
A drum that hums without turning, a burning rubber smell or a spin that never reaches speed, traced to the belt, the coupling, the motor or its control.
Shows up asWasher Not Spinning
The wash finishes but the drum barely turns at the end, and the clothes come out dripping wet.
MakeLG
Front-load and top-load washers from the Korean maker, known for direct-drive motors and detailed error codes.
SourceLG US Help Library: LG front load washer error code list (Wayback copy, 7 Sep 2026)
LG front-load washers; LG's washer list also uses CE on some other models for a drum that fails to reach speed.
Before you book,
in this order.
Each step comes from LG's own guidance for CE on its washers. Follow it to the end: the last card says whether this is a visit.
Unplug the washer for 10 seconds, plug it back in and try a cycle.
If CE shows again, close the water faucets, leave the washer unplugged and book a visit.
Still there?
It usually turns into drive motor and belt repair. Book with the code and the model number.
What not to do
CE is not a door or drain message; it is an electrical warning about the motor circuit, so repeated restarts are not advised.
What you may
notice with it.
The washer problems CE tends to arrive with. Answer these at the washer before anyone is booked.
All problems
Washer Not Spinning
5 causes, cheapest first
Where CE usually leads
Drive motor and belt repair.
LG
washers.
Front-load and top-load washers from the Korean maker, known for direct-drive motors and detailed error codes.
LG washer repairMore LG codes
Drive motor on other makes
Front-load washer
A horizontal drum behind a sealed glass door, a rubber boot, a locking latch and a pump with a filter you can reach from the front.
Top-load washer
The upright washer with a lid on top, moving clothes either with a tall central agitator or with a low impeller plate in the bottom of the basket.
Stackable washer
The washer at the bottom of a stacked pair or a single-frame laundry center, repaired inside the closet or recess it was sized for.
In LG's own words
The CE error code indicates that there has been an over-current in the electrical circuit of the motor.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. LG front-load washers; LG's washer list also uses CE on some other models for a drum that fails to reach speed.
LG CE washer repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about CE.
Can I clear CE myself?
Is it safe to keep resetting CE on my LG washer?
Could CE on an LG washer be caused by my house wiring?
Back to your everyday
Still showing CE?
Book with the code as it appears, the full model number, and whether any water is on the floor — for a code, that is where the diagnosis begins.